Metal loop gripper, for bars with an m10 diameter.
Very easy to use, for hanging a lamp.
1. Cut the lamp pipe to the correct size.
2. Clamp the loop gripper to the end of the pipe by clamping the bolt.
So you don't have to tap a thread on the end of the tube.
Handy tip (for extra strength):
Make a small notch with a hacksaw in the pipe and tighten the bolt.
Then the hanging loop has more grip and cannot slide out of place quickly.
This loop gripper is suitable for hanging light pendant lamps, up to approx. 4-5 kg / 9-11 pounds
The loop is provided with an earth screw.
Dit model is zonder schroefdraad
Geschikt voor M10 stangen
|Width (cm):||at largest point: 3.0 (1.2 inch)|
|Heigth (cm):||3.6 (1.4 inch)|
|Wire:||without screw thread, M10 opening|