15,95

15.95 / Piece



Stock: 13 Piece
Article code: 3-2511

Copper lampshade holder for lampshades, in a sleek / sober design. You place this holder over the upright edge of the lampshade. Then use the 3 screws to clamp the cover. Note: tighten the screws, but not too tightly (it remains a glass cap). A loop gripper (hanging loop) is also a handy part if you hang the lamp on a chain.

Technical state

De binnenmaat van de ring (waar de glazen kap in komt) is: 6.0 cm

De 3 schroefjes vast draaien, maar niet té vast, het blijft een glazen kap

Diameter opening bovenin de glasdrager: M10 (of wel 1.0 cm)

Specifications
Material: brass
Colour: gold
Outer Diameter (cm): 7.0 (2.76 inch)
Heigth (cm): 3.2 (1.26 inch)
Lamp shade holder (inner diameter, in cm): 6.0 (2.36 inch)